You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
Comma Device
3bc6970546
|
3 weeks ago | |
|---|---|---|
| .. | ||
| README.md | 3 weeks ago | |
| debug_h7.sh | 3 weeks ago | |
| dfu_util_f4.sh | 3 weeks ago | |
| dfu_util_h7.sh | 3 weeks ago | |
| gdb.sh | 3 weeks ago | |
README.md
In-circuit debugging using openocd and gdb
Hardware
Connect an ST-Link V2 programmer to the SWD pins on the board. The pins that need to be connected are:
- GND
- VTref
- SWDIO
- SWCLK
- NRST
Make sure you're using a genuine one for boards that do not have a 3.3V panda power rail. For example, the tres runs at 1.8V, which is not supported by the clones.
Openocd
Install openocd. For Ubuntu 24.04, the one in the package manager works fine: sudo apt install openocd.
To run, use ./debug_f4.sh (TODO) or ./debug_h7.sh depending on the panda.
GDB
You need gdb-multiarch.
Once openocd is running, you can connect from gdb as follows:
$ gdb-multiarch
(gdb) target ext :3333
To reset and break, use monitor reset halt.