* Update values.py
Adding 2022 Santa Fe Limited drive train and sensors - 2.5T with Dual Clutch Transmission which is different than the SE/VRT/SEL models.
* Update selfdrive/car/hyundai/values.py
* Add back other FW
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* added missing FW for 2022 Elantra SEL
I connected the Comma 3 with Hyundai K Harness and the vehicle was unknown. I worked my way through fingerprint 2.0 and compared the FW I had with this file and added the missing firmware to the Elantra_2021 section. I then went for a drive and it worked as intended. A number of the fwVersion were already there and so I've only added the ones that were missing.
* removed erroneous entries
removed entries that were not labeled Hyundai that I had added.
* VW PQ: Volkswagen Passat NMS
* regen CARS.md
* vEgo from Bremse_1 vehicle speed
* sync opendbc to master
* handle checksums and counters in opendbc
* LDW HUD message handling
* GRA_Neu_Zaehler -> COUNTER
* bump opendbc
* stub in till we find platform ACC standstill
* bump opendbc
* bump opendbc
* placeholder lateral accel data
* regen CARS.md
* counters now directly supported in opendbc
* additional door-open signals
* add trunk lid state
* add doors and trunk lid to signals list
* LDW_Status updates and passthrough
* bump opendbc for typo fix
* update AWV comment
* another comment update
* regen CARS.md with PQ in dashcam only
* don't show NMS footnotes while still in dashcam
* polish
* add stubbed-out dashcamOnly prep
* VW MQB: Cleanup stock ACC button handling
* bump opendbc and panda
* use controls resume output as trigger
* these can wait until taco bell
* bump opendbc
* pass through of previously fixed value
* retry CI
* checks already done in carcontroller
* don't need these anymore
* reduce diff for now
* slightly better abstraction
* more engine and trans FW
* turn signal is instantaneous stalk position
* weak sauce :(
* better clarity
* try torque tune
* add test route references
* bump opendbc and panda for OP long
* don't show steering faults for 3 seconds after start
* longitudinal control senders
* a little more torque
* test hax to torque control
* test a little more delay
* allow use of manufacturer ramp-up rate
* soften wheel-touch threshold
* Revert "test hax to torque control"
This reverts commit d1af459c29e36264aae406f72b8fcbc9ef22b9e0.
* punch it Chewie
* better ACC state and mainswitch handling
* a little more
* tweak max accel gradient
* oops
* also oops
* stuff
* srsly
* that's not how this works
* regen CARS.md
* footnotes now properly excluded for dashcam cars
* this wasn't a problem
* update network location detection
* bump submodules for ACC main switch
* clean up DBC references and long flag
* bump one more time
* one more time
* follow CANPacker counter refactor
* bump opendbc
* sync opendbc to master
* bump panda to fix Subaru tests
* DBC handling cleanup
* fix
* model-year stretch
* cleanup and rate bugfixes
* better abstractions
* simplify create_lka_hud_control
* volkswagencan -> mqbcan
* bump panda
* fix doc data bug, regen CARS.md
* style updates; diff reduction
* use common button enable logic
* not needed anymore
* refactor TSK and HUD enum values
* make common button events function
* consistency
* bump panda
* bump panda
* dashcam only
* don't need process_replay yet
* regen CARS.md with Passat NMS in dashcam
* can't handle dashcam-orphaned footnotes yet
* remove outdated standstill handling
* editor tried to be too helpful at some point
* don't need to import this anymore
* Apply suggestions from code review
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* follow parkingBrake refactor
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* Revert "FPv2: fingerprint on all FW combinations (#25204)"
This reverts commit ee081f278b.
* Revert "Revert "FPv2: fingerprint on all FW combinations (#25204)""
This reverts commit bb68b7bc1c28ba8c67f3051b8f99fabc42e85771.
* For breaking, match only with current brand's FW
* Add comment for fuzzy matching
* fingerprint (online) only using FW from that brand
* test_fw_query_on_routes fingerprints like online
* extend match_fw_to_car to work for test_fw_query_on_routes
* Apply suggestions from code review
* Switch to ECMPRDNL2 for GM gear
* Removing manumatic gear #
* values.py almost complete
* Silverado and Bolt EUV val and CP
* GM controller updated
* Cam hrns supp done (in theory)
* cleanup for new cars
* Remove extra constant
* WS, etc cleanup
* removing the unused
* Fix kpBP typo
* Updated docs
* Skip's PIF tune
* Dropped LKA CAN error patch
* Add silverado sigmoid ff
* CAN Err & LKA latch patch
* Remove EPS fault fix (another PR)
* Remove Silverado (another PR)
* clean up some common params
* Remove Escalade FP
Remove Escalade FP
* comment
* Premier is just a trim
Premier is just a trim
Premier is just a trim
* no footnote: new Bolt is like most other cars, older GM were outliers not at the camera
* clean up
clean up
* bump panda
* bump panda
* bump panda
* bump panda
* bump panda
* remove comments
* try spamming buttons on bus 2
* bump panda
* bumping opendbc w btn rc
* not needed for this port
This reverts commit 6af1f0ba799e075f877d7acc8ca0f117d97da361.
* add button safety
* Send next rc when spamming btns
* forward other signals in message
* missing DriveModeButton
* fill cruiseState.speed
* see if resume works without counter
* try the whole message
* send immediately and at 10Hz
* no resume, back to just button signal
* even holding random buttons it cancels
* Use torque controller with base tune
* stock long GM don't auto-resume yet
* Testing GM zero min steer speed
* Revert latcontrol
* revert opendbc
* latActive is basically lkas_enabled
* Update Bolt torque params
* comment
* clean up
* Add to releases
* Add test route
* Don't specify segment
* bump panda
* bump panda
* no harness for Bolt just yet
* Apply suggestions from code review
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* We support all and 2023
* move safetyParam up to first cam check
* Bump panda and update docs
* Update RELEASES.md
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
Co-authored-by: Shane Smiskol <shane@smiskol.com>
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* Skoda unsupported connector footnote; note J533 alternative isn't available on all cars
* limit footnote to Karoq
* Update docs
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* Ram HD Init
* Update selfdrive/car/torque_data/override.yaml
* Revert FW for 1500
* little cleanup plus test route
* bump panda
* revert 1500 changes
* bump panda
* same error max
* dashcam + cleanup
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* GM: separate EV/ICE gas/brake lookup tables
* removed blank line
* V are the same
* comment
better ordering
comment
comment
* Add some delay for the laggy brakes
Add some delay for the laggy brakes
* move actuator to only acadia
* start braking at 0 m/s/s
* Revert "start braking at 0 m/s/s"
This reverts commit 55c1dee733aab3dc037fb1705c9bd0ace55c849f.
* add delay for escalade
* revert EV changes
* Update selfdrive/car/gm/carcontroller.py
* comment
* only ACADIA
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* Rebase and merge upstream
* Bump panda
* bump panda
* todo comments, minor clean up
* Add test route
* send CLU11 on bus 2
* Update docs
* Use Chrysler cp ternary naming convention
* Add FW version
* Update with latest test route
* Use segment with engaging/disengaging and moving
* sort FW
* push ci route
* add comment
* bump panda
* bump panda
* clean up
* Limit torque
* bump panda
* bump panda
* bump panda
* Add missing FW
* Add CAN fingerprint (need to fix spotty queries)
* missing fingerprints
* bump panda
* use O
* It's 2022, how is SCC still not standard!
* space
* bump panda to master
Co-authored-by: Shane Smiskol <shane@smiskol.com>
Alex Vazquez
Adeeb Shihadeh
Shane Smiskol
Squiggle Squaggle
Jason Young
Chris Souers
khoi
MadBrad
kravatch
Jason Shuler
Jason Wen
Kento Tokuhiro
John Belmonte
realfast
royjr
Tim Wilson
cydia2020