* start cleanup
* create generated dir if not exist
* tests pass!
* everything works again
* also convert live_kf to new structure
* Remove sympy helpers from file list
* Add laika to docker container
* Only build models that are present
* Only show update alert if updater failed
* no negetive days in warning message
* Also increase failed count when no internet
* Only set count to zero on actual update
* First run always fails because IsOffroad is not set yet
* added 2020 highlander (TSS2)
* add HIGHLANDER_TSS2 test into routes
* reduce HIGHLANDER_TSS2 weight to 4700 from 4900
* add highlander 2020 limited to the list of supported cars
* Resume Required Alert should be triggered off of ECM state
On GM cars the ECM goes into cruise state 4 (standstill) and in order
for the ECM to accept cruise inputs, the resume button must be pressed
to drive it to state 1 (active).
Previously rather than testing for if the ECM was in state 4, the wheel
speed sensors were checked that the vehicle was going less than 0.5 m/s.
In some cases this could cause the resume required alert to be displayed
before the car actually came to a stop as far as the ECM was concerned.
If the alert is triggered before state 4 and OP demands acceleration,
its possible for OP to acelerate while the Resume Required Alert is
displayed created a very confusing UX.
* After more review, the problem was actually with the 'if at_full_stop' check was inside an else statement preventing entering the stopped mode if braking is 0
Harald Schafer
Willem Melching
ZwX1616
wocsor
Patipat Susumpow
IppSec
andyh2
Comma Device
che220
Arne Schwarck
George Hotz
andrewcopenpilot