* add delay to GM camera ACC cancel to avoid FCW and cruise fault
* we can revert brake pressed threshold now
* bump panda
* add proper threshold
* bump
* bujmp panda
* add all signals
* try to forward this PSCMStatus
* fixes
* see if this works
* modify checksum when bit flipped
* bump opendbc
* so i can test without restarting
* bump
* bump panda
* clean up
* comment
* also fix this
* bump
* bump
* every 5 seconds
* only send our values
* fix
* try sending everything again (+1 counter)
* revert
* revert, forward msg
* forward
* fix that
* bump panda
* bump panda
* fine to not copy
* after cancel, pass bus
* fix
* Revert "fine to not copy"
This reverts commit 654ac1a7da.
* fix the fault more generically
* fix
* need this
* some clean up
* comment and use standstill
* comment
* add comment
* better fix
* rm
* better (for now)
* update docs
* prevent bolt fault
* comment
* only for camera ACC
* fixup alert
* bump cereal to master
* use new name
* Update selfdrive/car/gm/interface.py
* Update selfdrive/car/gm/interface.py
* Update selfdrive/car/gm/interface.py
* only care about prevent engagement when we look at PCM
* GM camera ACC: no faults on start up 2.0
And by 2.0 I mean we don't need to wait for blocked msg support to be merged first to merge this without regressing accidental single blocked msg count handling.
* Send the camera counter + 1
* Keep updating the first counter until we get a message on the bus
* Only update right before sending so sent_lka_steering_cmd is updated first
* Update ref_commit
* This brake position value disengages stock ACC, use it to avoid controls mismatch. 2016-2017 Volt will hit this threshold and disengage, must install new design of brake pedal retaining clip, TSB 16-NA-147.
* 80 hz
* comment
* bump panda
* update refs
* bump panda
* bump panda
* bump panda
* bump panda to master
Co-authored-by: qadmus <42746943+qadmus@users.noreply.github.com>
* -4 didn't make any sense?
* comments
* comments
* update to 400
* bump panda
* remove unused iso limit vars
* update comments
* bump panda
* Update selfdrive/car/gm/values.py
* Update ref_commit
* Chevy Bolt EV w ACC Port
* dashcam
* The website allows you to select the package without ACC
* fix Bolt E(U)V centerToFront
* Update selfdrive/car/gm/values.py
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* Chevy Equinox Port
* LKAS is not standard on 2019, but it's the same package as ACC. (LKAS standard 2020+)
* 2019 here too
* clean up
* add to untested
* not in docs
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* single longitudinal toggle for e2e and disable radar
* write disable radar param
* rename
* better param name
* clean that up
* update refs
* update translations
* not live for experimental
* write it out
* vanish
* Move auto resume in sng to car interface
* Update docs
* shorter name, star
* order
* resumes?
* add hidden detail sentence
* good to know this works, but revert
* VW auto resume
* bump cereal to master
* Update ref_commit
* match cereal
* try this
* ?
?
* like this
* Silverado support
Co-authored-by: Jason Shuler <jshuler@gmail.com>
* Update docs
* Try 2 m/s/s
* Should be good torque values
* Add Silverado test route
* Add to releases
* Send counter
* can't send multiple or it faults
* Send at 33hz, no counter
* try 25hz, don't line up exactly with car's buttons
* never tried 10hz with same counter
* Update selfdrive/car/gm/gmcan.py
* Make same as pcmCruise branch
* update year and package (different packages needed per-trim)
* Update year in releases
* Revert to 21
* We can use this package name again
* wrong one!
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* Switch to ECMPRDNL2 for GM gear
* Removing manumatic gear #
* values.py almost complete
* Silverado and Bolt EUV val and CP
* GM controller updated
* Cam hrns supp done (in theory)
* cleanup for new cars
* Remove extra constant
* WS, etc cleanup
* removing the unused
* Fix kpBP typo
* Updated docs
* Skip's PIF tune
* Dropped LKA CAN error patch
* Add silverado sigmoid ff
* CAN Err & LKA latch patch
* Remove EPS fault fix (another PR)
* Remove Silverado (another PR)
* clean up some common params
* Remove Escalade FP
Remove Escalade FP
* comment
* Premier is just a trim
Premier is just a trim
Premier is just a trim
* no footnote: new Bolt is like most other cars, older GM were outliers not at the camera
* clean up
clean up
* bump panda
* bump panda
* bump panda
* bump panda
* bump panda
* remove comments
* try spamming buttons on bus 2
* bump panda
* bumping opendbc w btn rc
* not needed for this port
This reverts commit 6af1f0ba79.
* add button safety
* Send next rc when spamming btns
* forward other signals in message
* missing DriveModeButton
* fill cruiseState.speed
* see if resume works without counter
* try the whole message
* send immediately and at 10Hz
* no resume, back to just button signal
* even holding random buttons it cancels
* Use torque controller with base tune
* stock long GM don't auto-resume yet
* Testing GM zero min steer speed
* Revert latcontrol
* revert opendbc
* latActive is basically lkas_enabled
* Update Bolt torque params
* comment
* clean up
* Add to releases
* Add test route
* Don't specify segment
* bump panda
* bump panda
* no harness for Bolt just yet
* Apply suggestions from code review
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* We support all and 2023
* move safetyParam up to first cam check
* Bump panda and update docs
* Update RELEASES.md
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
Co-authored-by: Shane Smiskol <shane@smiskol.com>
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* GM: separate EV/ICE gas/brake lookup tables
* removed blank line
* V are the same
* comment
better ordering
comment
comment
* Add some delay for the laggy brakes
Add some delay for the laggy brakes
* move actuator to only acadia
* start braking at 0 m/s/s
* Revert "start braking at 0 m/s/s"
This reverts commit 55c1dee733.
* add delay for escalade
* revert EV changes
* Update selfdrive/car/gm/carcontroller.py
* comment
* only ACADIA
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* add well maintained footnote
* stash
* some updates for the website
* one extensible sort function, pass sort function into template, continue to use "openpilot ACC"
* use items
same
* return a final dict
* Fix descriptions
* Required
* Add detail sentence
* Make string packages into namedtuple
* add temp year parsing
* revert this
* one unified class like harness
* fix static analysis
* Fix body
Fix body
* Make specifics strong
* remove years
* Make Camry footnote more clear
* Revert this too
* Add notCar text, fix steer speed > enable speed (remove comma, no speed mention)
* fix missing years
* group_by_make
* Use full package text
* Only use full package text
* Check car name if notCar, fix imports
* add_years no longer needed, remove 'with Stop and Go'
* fix that
fix that
fix that
* Exception for Nissan and Subaru
* Adjust DSU footnote text
* Fix speed overrides in sentence, CR-V package imp
* init() was being called multiple times, only need to run once to set row
* Interface radarOffCan set, comments
* pass pcmCruise value to common events
* add transType and networkLoc to iface
* carstate use transtype to detect EV
* ctrl: limit sends by config
* Add clarifying comments for new vals
* clean up
* comment on new line
* these have the same frequency
* remove 25hz
* add to upper comment
* update refs
* update refs
* move into same block
move into same block
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* json
* better naem
* Read from table
* formatting and default to nan
* Generate docs
* Read from table
* this should be the same
* Prius v is full
* test we always set the tunes correctly
add to release files
* Set for all cars
Set for all cars
* Revert tuning changes
Revert tuning changes
* remove that
* fixes
* update ref commit for new maxLateralAccels
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* Set good torque using torque controller tuning
* should be equal to
* save lateral accel to car params
* use maxLateralAccel
* always
* same convention
* nan will always evaluate to false
* The great good torque purge
* adjust default friction
* Add data for more cars
* adjust name
* Welcome back, guys. Only adjust good torque if maxLatAccel is set
* Update refs (1.7 is 1.7000001...)
* function for creating button events
* fix
* one line
* alphabetical
alphabetical
* only needed once
* common function for enable events
* add to list
* extend
* fixes
* add type hints
* flip around
Shane Smiskol
Jason Shuler
Cameron Clough
Adeeb Shihadeh
MadBrad
Tim Wilson
HaraldSchafer