* Toyota: pass through sway warning system signals
* signal doesn't seem to exist on the Prius V
bad log?
* remove duplicated checks
* syntax
* Revert "syntax"
This reverts commit 6c30c30d46.
* Revert "remove duplicated checks"
This reverts commit 6a364984eb.
* Revert "signal doesn't seem to exist on the Prius V"
This reverts commit 57fa571fde.
* Revert "Revert "signal doesn't seem to exist on the Prius V""
This reverts commit 9b1c3f6cac.
* Revert "Revert "remove duplicated checks""
This reverts commit 38bc7f3de6.
* Revert "Revert "syntax""
This reverts commit f81f93631f.
* hard code values for Prius V
* send ui once every 25 frames
remove send ui logic
* send UI immediately on pcm_cancel_cmd
* draft
* clean that up
* same order as toyotacan
* update refs
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* note for dsu cars
* don't hardcode dsu footnote (1/2)
* test
* revert the experimental long toggle
* another day:(
* DSU doesn't have to be toyota specific, it's a generic carParam!
* this is safe, just make sure it's unknown
* these cars do not have OP long for some reason
* UNSUPPORTED_DSU_CAR
* forgot this
* .
* .
* revert
* revert
* smaller diff
* try a method to kill those faults
* cut torque for 1 frame
* sign doesn't seem to matter
* clean up
* better name
* Toyota allows you to keep your apply_steer, better control
* the logic was wrong entire time?
* cut steer for two frames
* Revert "cut steer for two frames"
This reverts commit 13a68ecc56.
* better variable names and comments
better variable names and comments
* should be good
* add safety
* actual number of frames
* constant
* bump panda
* bump panda
* bump panda
* bump panda
* bump panda
* bump panda
* bump panda
* fix to use min valid frames
* rm line
* simplify check
* bump panda
* bump panda to master
* Toyota: fill steerFaultPermanent
* same behavior as before, 0 is also fault (0 is most likely initializing)
* think this was just wrong (2 or 10 would mean we think it's a fault)
* Initial commit
* Fix bugs
* Need more torque rate
* Cleanup cray cray control
* Write nicely
* Chiiil
* Not relevant for cray cray control
* Do some logging
* Seems like it has more torque than I thought
* Bit more feedforward
* Tune change
* Retune
* Retune
* Little more chill
* Add coroll
* Add corolla
* Give craycray a good name
* Update to proper logging
* D to the PI
* Should be in radians
* Add d
* Start oscillations
* Add D term
* Only change torque rate limits for new tune
* Add d logging
* Should be enough
* Wrong sign in D
* Downtune a little
* Needed to prevent faults
* Add lqr rav4 to tune
* Try derivative again
* Data based retune
* Data based retune
* add friction compensation
* Doesnt need too much P with friction comp
* remove lqr
* Remove kd
* Fix tests
* fix tests
* Too much error
* Get roll induced error under 1cm/deg
* Too much jitter
* Do roll comp
* Add ki
* Final update
* Update refs
* Cleanup latcontrol_torque a little more
* do tesla
* parentheses
* Do Chrysler
* Make sure Hyundai long never actuates when long inactive
.
* clean up Hyundai
* more clear
* formatting
* Stock sets these to zero
* fix params
* move jerk logic into CC
clean up
* proof of concept
* actuators packet describes which actuators are active
* bump cereal
* fixes
* not needed for this PR
* Do Toyota
* add back controlsState.active
* bump cereal
* rest of cars
* in actuators
* add active back
* which
* use controlsState.active for now
* will make an issue
* Update selfdrive/controls/controlsd.py
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* move local lat_active checks into CC.latActive
* remove redundant checks
* move comment
move comment
* fix joystick mode
* get enabled from carcontrol
* do standstill check in controlsd
* make sure we consider the gas press case for GM
* use CC.actuators
* fix
* capitalization
* Bump cereal
Bump cereal
* make intermediate actuators
* similar convention to before
* clean that up
* update refs
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* check in tuple instead of list
* Update selfdrive/car/toyota/carcontroller.py
Co-authored-by: Willem Melching <willem.melching@gmail.com>
* Update selfdrive/car/mazda/interface.py
Co-authored-by: Willem Melching <willem.melching@gmail.com>
Co-authored-by: Willem Melching <willem.melching@gmail.com>
sshane
cydia2020
Adeeb Shihadeh
HaraldSchafer
Cameron Clough
Dean Lee